Panasonic HDC-HS9, Руководство по эксплуатации

Страница: 37 / 132

37
VQT1N87
This unit will resume recording/pause mode
about 0.6 seconds after the LCD monitor is
reopened.
≥ When in quick start standby mode about
60% of the power used in recording pause
mode is being consumed, so the recording
time will be reduced.
1
Select the menu. (
l
23)
2
Close the LCD monitor while the
mode dial is set to
or .
The status indicator
A
flashes green and the unit
goes into quick start standby mode.
≥
The lens cover does not close.
3
Open the LCD monitor.
The status indicator
A
lights red and the unit is
put into recording pause approx. 0.6 seconds
after it is turned on.
≥ Set [QUICK START] to [OFF] to cancel the
quick start mode.
≥
Quick start standby mode is cancelled if
j
about 5 minutes elapsed
j
Set the mode dial to
j
Turn the unit off
≥
In the 25p digital cinema setting, the required
time for the quick start operation is slightly
longer than 0.6 seconds.
≥ In the quick start mode, it may take some time
for automatic white balance to adjust, if the
scene being recorded has a light source
different from the scene last recorded. (When
the colour night view function is used, however,
the white balance of the scene last recorded is
retained.)
≥
In the quick start mode, the zoom
magnification becomes 1
k and the picture size
may differ from what it was before quick start
standby mode.
≥ If [POWER SAVE] ( l 24) is set to
[5 MINUTES] and the unit automatically goes
into quick start standby mode, close the LCD
monitor and then open it again.
≥
If the unit is exposed to vibration or shock, the
time for the quick start mode may be slightly
longer than 0.6 seconds.
This allows recording of the pictures and sound
to start approximately 3 seconds before the
recording start/stop button is pressed.
1
Press the PRE-REC button.
[
[ ] appears on the screen and the unit
repeats the update by recording motion pictures
for about 3 seconds onto the built-in memory and
then deleting them.
≥
Aim this unit at the subject and position it
securely.
≥
Press the PRE-REC button again to cancel the
setting.
2
Press the recording start/stop
button to start recording.
≥ Images and audio are recorded for about
3 seconds before pressing the recording start/
stop button.
≥ There is no beep sound.
≥
After recording starts, the PRE-REC setting is
cancelled.
≥ To use the PRE-REC function again, press the
PRE-REC button again.
Quick start
[SETUP] # [QUICK START] # [ON]
PRE-REC
This prevents you missing a shot.
PRE-REC
HDCHS9EP-VQT1N87_eng.book 37 ページ ２００８年１月１１日 金曜日 午後７時５２分