23
(ENG) DVQX1483
Inserting/removing an SD card
Caution:
Check that the access lamp has gone off.
1
Open the SD card slot cover and
insert (remove) the SD card into
(from) the card slot
B
.
≥
One SD card can be inserted into each of the
card slot 1 and the card slot 2.
≥
Face the labelled side
C
in the direction
shown in the illustration and press it straight
in as far as it will go.
≥
Press the center of the SD card and then pull
it straight out.
2
Securely close the SD card slot
cover.
≥
Do not touch the terminals on the back of the
SD card.
≥
Do not apply strong shocks, bend, or drop the
SD card.
≥
Electrical noise, static electricity or the failure
of this unit or the SD card may damage or
erase the data stored on the SD card.
≥
When the card access lamp is lit, do not:
j
Remove the SD card
j
Turn the unit off
j
Insert and remove the USB Cable
j
Expose the unit to vibrations or shock
Performing the above while the lamp is on
may result in damage to data/SD card or this
unit.
≥
Do not expose the terminals of the SD card to
water, dirt or dust.
≥
Do not place SD cards in the following areas:
j
In direct sunlight
j
In very dusty or humid areas
j
Near a heater
j
Locations susceptible to significant
difference in temperature (condensation
can occur.)
j
Where static electricity or electromagnetic
waves occur
≥
To protect SD cards, return them to their
cases when you are not using them.
≥
About disposing of or giving away the SD
card. (
l
7)
When using an SD card for the first time, it is necessary to format the SD card. (
l
27) When the
SD card is formatted, all of the recorded data is deleted. Once the data is deleted, it cannot be
restored.
ビ
ヒ
Access lamp
A
≥
When this unit is accessing the SD card,
the access lamp lights up.
HC-MDH3EGCGW-DVQX1483ZA_eng.book 23 ページ ２０１８年２月６日 火曜日 午後２時２７分
