12
VQT1Y00
Quick Guide
∫
Charging the battery
1
Connect the AC cable to the AC adaptor and
the AC outlet.
2
Insert the battery into the AC adaptor by
aligning the arrows.
∫
Inserting the battery
Install the battery by inserting it in the direction
shown in the figure.
A
Insert the battery until it clicks and locks.
∫
Inserting/removing an SD card
1) Open the LCD monitor.
≥
Check that the access lamp has gone off.
2) Open the SD card cover by sliding the OPEN
lever
B
.
3) Insert/remove the SD card.
≥
Face the label side
C
in the direction shown in the
illustration and press it straight in as far as it will go.
≥
Press the center of the SD card and then pull it
straight out.
4) Securely close the SD card cover.
≥
Securely close it until it clicks.
∫
How to turn on the power
Turn on the power by changing the mode to
or
while pressing the lock release button
A
.
≥
To turn off the power, change the mode to OFF.
Access lamp [ACCESS]
A
≥
When this unit is accessing the SD card or
built-in memory, the access lamp lights up.
Charging lamp
[CHARGE]
A
Lights up:
Charging
Goes off:
Charging
completed
OPEN
≥
Operate the mode switch while at the same
time pressing in the lock release button if
changing from OFF to another mode.
≥
Status indicator
B
HDC-SD20
HDC-TM20
≥
Rotate the mode dial while at the same
time pressing in the lock release button if
changing from OFF to another mode.
≥
Align with the status indicator
B
.
OFF
HDC-HS20
HDCSD20&SD25&HS20P-VQT1Y00_eng.book 12 ページ ２００８年１２月２２日 月曜日 午後８時１６分
