15
Parts and their functions
<Rear panel>
<Bottom panel>
1
Remote controller signal receiver
Light sensors are located in two places at the front of the
camera pedestal.
Used when the remote control through function and IR
repeater function are used (pages 13 and 14).
2
Status display lamp
This lights in the following way depending on the status of
the unit.
Orange:
Standby mode (page 19)
Green:
Power ON mode (page 19)
Red:
When trouble has occurred in the unit
Green and blinks twice:
When signals from the remote controller are
received
3
Camera head
This rotates in the horizontal direction.
4
Lens unit
This rotates in the up and down direction.
5
HDMI connector [HDMI]
This is the HDMI video output connector.
6
IR system/service connector [IR/SERVICE]
Connect the IR system cable to this connector. (See
page 17.) The connector is also used for maintenance
purposes.
7
Anti-theft wire mounting hole
Use this hole to attach the wire bracket.
8
DC IN connector [16V IN
]
Connect the AC adapter supplied with the unit to this
connector to supply the DC 16 V voltage to the unit.
9
Threaded hole (thread: 1/4-20UNC) for mounting
the camera
Use this hole when mounting the camera on a tripod, etc.
:
Service switches
ON
OFF
SW1 SW2
SW1:
Always set this switch in the “OFF” position for
use.
When this switch is set in the “ON” position
during use, video output may be disabled.
SW2:
Set this switch in the “OFF” position to perform
the pan/tilt operation at normal speed.
Set this switch in the “ON” position to perform the
pan/tilt operation at low speed.
;
IR system/service selector switch
Set this switch at the “IR” position for use.