12
Part Names and Functions
2
Power port
Serial Number label
Power cord hook block
Back panel
Power port
Connect the supplied power cord to this port and connect the other end into an
electric outlet.
Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull
out from the power port.
Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
10/100/1000BASE-T ports (ports 1-6)
Ports 1 to 4 can supply PoE power confirming with IEEE802.3at/af.
Devices such as 10/100/1000BASE-T terminal, hub, repeater, bridge, and Switching Hub
can be connected to this port. Install the device so that the length of twisted pair cable
(CAT5e or above) becomes 100m or less.
SFP extension slot (ports 5,6)
Install SFP module. (It becomes exclusive usage with twisted pair port.)
When SFP extension slot is linked, the ports is automatically switched to SFP
extension mode.
SFP port supports only the full duplex communication.
Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage
this Switching Hub.
Console port
Ground terminal
Front panel
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
: 1 bit
Flow control
: None
Emulation mode
: VT100
Data length
: 8 bits
Parity control
: None
Transmission connector : RJ45
10/100/1000BASE-TX ports supporting PoE power supply
10/100/1000BASE-TX ports
SFP extension slot
