Panasonic FZ-M1 Series, Руководство пользователя

Страница: 14 / 18

*1 : Screen messages are explained in [English (United States)].
(Depending on the language preference, some screen messages in these instructions are different from the actual screen
messages. For example, [Flight mode]/[WiFi] may be displayed instead of [Airplane mode]/[Wi-Fi] in some language
preference.)
*2 : In the case of wireless communications, the frequency band being used can be divided into segments, so that different
communications can be conducted on each band segment. A “Channel” refers to the individual frequency bandwidth
divisions.
Restart the computer.
Access point is not detected.
Shorten the distance between the computer and the access point, and try the
detection again.
Confirm the following settings:
[Wireless LAN] in the [Advanced] menu of the Setup Utility
Confirm that [Wireless LAN] of [Wireless Configuration] is set to
[Enabled].
Airplane mode
Confirm that Wireless LAN ([Wi-Fi]) is [On].
This computer uses channels 1 through 11
*2
to [On] when using
IEEE802.11b/g/n. Check the channel being used by the access point.
<Only for model with wireless
WAN>
Cannot communicate.
Confirm the following settings:
[Wireless WAN] in the [Advanced] menu of the Setup Utility
Confirm that [Wireless WAN] of [Wireless Configuration] is set to
[Enabled].
Airplane mode
Confirm that Wireless WAN (Cellular) is [On].
Confirm that the microSIM card is inserted correctly.
If communication is not established after proceeding with the above remedies, the
wireless WAN device may not be correctly recognized. Restart the computer.
<When using the GPS function on
the model with the built-in Wireless
WAN modem>
COM port number setting is
requested when trying to use the
GPS function.
To use a COM port, follow the steps below.
1. Uninstall “Sierra Wireless Mobile Broadband Driver Package”.
1. Touch (Settings) - [Apps].
2. Touch [Sierra Wireless Mobile Broadband Driver Package], and
then touch [Uninstall].
Alternatively, touch (Start) - (Settings) - [Apps] in
the desktop mode.
3. Touch [Sierra Wireless Mobile Broadband Driver Package], and
then touch [Uninstall].
4. Touch [Uninstall].
2. Restart the computer.
3. Touch and hold (Start) - [Run], and then input
“C:\util\drivers\wwan_xx\Port_install.bat” in [Open:], and touch [OK].
(“xx” will vary depending on the model.)
4. Confirm that “Sierra Wireless NMEA Port(COMx)” is displayed, open the
device manager, and then touch [Ports(COM & LPT)].
Specify “COMx” as the COM port number.