Panasonic FV-KTB2SD1HK, Руководство по установке

Страница: 12 / 14

Installation method Installation method
(continued) (continued)
④ According to Fig.5, take out the smoke duct and the short duct adapter (both have been fi xed with aluminum
foil tape), and keep the smoke duct in a compressed state. Pass the adapter ring from top to bottom through
the smoke duct and the short duct adapter in sequence to the limit for use, and secure the above components
using the four clips of the adapter ring to interlock them with the outlet seat. Connect the power supply, start
the motor, and check if the two metal pieces are turned up. Turn off the range hood, and make sure that the
two metal pieces drop down naturally.
⑤ Securely attach the unit to the appliance hang board with the unit inclined 1 ° or 2 ° to the wall, so that the
hooks of the appliance hang board are fully inserted, so that the hooks of the appliance hang board are fully
inserted. After installation, make sure that the range hood is not shaking or detached, and try to ensure that it
is in a horizontal state. Stretch the smoke duct, extend it into the wall opening or connect it to the common fl ue
securely, and adjust the smoke duct to ensure that it is not bulging or compressed, and it bends freely. If the
smoke duct is extended directly into the common fl ue, it shall not go too deep into the common fl ue, so as not
to affect exhaust effect; if oil fume is exhausted directly to the outside, it is suggested that a shutter (available
in hardware stores) be attached at the end of the outdoor smoke duct.
⑥ Insert the power plug into the socket securely. The power socket shall be a special one with a reliable
grounding wire. Do not change the plug without permission.
⑦ As shown in Fig.6, use a screw (ST5 × 19) to fi x the stop block on the wall through a plastic expansion tube to
prevent the range hood from falling off vertically in case of an external force.
Fig.3
Fig.5
Fig.6
Fig.4
③ According to Fig.3, align with the screw holes and place the sealing pad and the adapter on the outlet in
sequence after removing the adapter ring from the adapter. After aligning with the screw holes, use 8 self-
tapping screws removed in step ② to fi x the sealing pad and the adapter to the unit.
Note:1.Be sure to remove the adapter ring. Otherwise, it is impossible to install the smoke duct.
2.The direction of adapter after installation shall be the same with that shown in Fig.4.
Stop block
② According to Fig.2, use a Phillips screwdriver to
remove 8 self-tapping screws at the adapter and take
out the sealing pad.
Fig.2
12