Ventilating fan
Adapter
Long screws
Ceiling
Flange
Fig. 14
Fig. 15
9
Installation (Wooden header installaton)
II
Before installation, secure adapter to fan body using
two thumb screws.
Install header between ceiling joists using nails or screws.
Secure the Fan/Light assembly to the header with long
screws (M4X30).
Slide the 4" circular duct onto the adapter and secure
with tape. Remove the junction box cover and secure
conduit to junction box knockout hole. (7/8 inch)
Refer to wiring diagram.
Using wire nuts, connect house power wires to ventilating
fan wires:
black to blacks; white to whites; green to greens.
Replace junction box cover.
Wiring Diagram
Finish ceiling work. Ceiling hole should be cut at the
edge of the flange.
Insert the lamp cover into the Grille and attach the grille
to the fan unit.
(Fig. 12)
(Fig. 13)
(Fig. 14)
(Fig. 3)
(Fig. 15)
(Fig. 11)
1.
Mount junction box cover carefully so that lead wires
are not caught.
CAUTION:
Junction box cover
Circular duct
Adapter
When connecting the light unit and fan unit seperately, read the note on page 6 before making connections.
Fig. 12
Fig. 13
3.
4.
5.
6.
7.
8.
(Fig. 14)
mm(inch)
Thumb screws
Light unit
Fan body
Ceiling joist
Header
Ceiling joist
235
(9 1/4)
345
(13 9/16)
Night Lamp
Black
White
Power Supply
AC120V 60Hz
Earth ground
Red
Black
Motor
Capacitor
White
Green
Lamp
Lamp
Light unit
Ballast
Black
Fan unit
Junction box
Green
Ballast
Power supply
AC 120V 60 Hz
Insert the plug connector
II
and plug connector
III
into the
receptacle
II
and receptacle
III
respectively. Install the light
unit to the fan body by using plastic screws (M4x13)
and one short screw
I
(M4x12).
Insert the fluorescent
lamps and screw the night lamp into the light unit.
2.
(Fig.10, Fig. 12)
