Panasonic EYFMH1WC, Руководство по эксплуатации

Страница: 21 / 44

- 21 -
EN
2.1.1 OPERATION MODE OF THE TOOL
2.1 BASIC OPERATION
The tool operates in one of the following modes.
The mode in which it is used now is shown on the display of the control panel.
Display
Display Mode name Mode details
Stand Alone
Mode
This is a mode in which the tool operates according to the
configured parameters registered in its inside.
The history log data is recorded in the tool’s internal storage.
The tool does not communicate with the controller.
The Tool Manager software is used to change the setting to
[Stand Alone Mode].
Refer to 2.2.8
Wireless
Communication
Mode
This is a mode in which the tool is controlled via wireless
communication.
The tool communicates with the controller to send the history log
data and receive the configured parameters.
Refer to 2.2.9
Operation
Disable Mode
The tool has been locked by an operation prohibition signal from
the controller in the wireless communication mode.
It will be unlocked by a release signal from the controller.
Pairing mode
This is a mode to check the pairing status.
It can also be done on the controller.
Refer to 3.3
Minimum
Output Mode
This is a mode in which to check whether torque control is
available when the target torque is low. The tool is shut off at the
minimum number of pulses.
The Tool Manager software is used to change the setting to
[Minimum Output Mode]. It can also be done on the controller.
Refer to 2.2.8
Offset Mode
This is a mode in which to correct the calculated torque of the
tool for the actual torque.
The Tool Manager software is used to change the setting to
[Offset Mode]. It can also be done on the controller.
Refer to 2.2.8
Factory Default
Mode
This is a mode in which the tool is in the factory default status.
Select [Stand Alone Mode] or [Wireless Communication Mode]
in accordance with your purpose using the Tool Manager
software before use.
EYFMH1WC_H2WC_WEB_EU.indb 17 EYFMH1WC_H2WC_WEB_EU.indb 17 2023/11/28 14:23:26 2023/11/28 14:23:26