EN
EN
- 11 -
EN
EN
• In order to prevent excessive increased
in temperature, do not operate the tool
continuously without interval after fin-
ishing a battery.
Tightening confirmation lamp
• The tightening confirmation lamp can be
used to check whether tightening has been
completed properly.
See the illustration
8
Tool status
Lamp display
Tightening complete
(Normal clutch operation)
Green
(For approx.
seconds)
• Tightening not complete
• Tightening complete
without fulfilling the set
function conditions
Red
(For approx.
seconds)
The automatic power-
off function has been
activated.
Red
(For approx. 5
minutes)
NOTE
• The tightening configuration lamp will
not turn on in reverse rotation mode.
• The tightening configuration lamp turns
off when the tool restarts an applica-
tion.
The battery indication lamp
See the illustration
9
• The battery indication lamp notifies user on
remaining battery power.
• Battery life varies slightly with ambient tem-
perature and battery characteristics.
Indicator
Battery status
Fully charged
Approx. 40% or less
remaining
Flashing
Flashing
Approx. 0% or less
remaining (indicates need
to recharge battery)
The battery pack will need
to be charged soon.
Flashing
No charge
The battery pack needs to
be charged.
(The tool’s automatic
power-off function will
activate at this stage.)
Automatic power-off function
• The automatic power-off function is designed
to prevent a loss of tightening torque due to
reduced battery voltage. Once it has been
activated, the tool will not operate until the
battery pack has been charged (or replaced
with a fresh unit), even if the trigger is
depressed.
NOTE:
• All 3 bars on the battery indication lamp
will flash when the automatic power-off
function is activated.
• Be sure that the battery pack is fully
charged, otherwise the automatic power-
off function may not activate properly.
• The tool may power off automatically
under heavy work loads.
However the tool will be operational
again after the battery is removed and
reinstalled. The battery must have a
sufficient charge to re-enable the tool.
LED light
See the illustration
9
Press the
button to turn on/off the LED
light.
NOTE:
• The light consumes very little power
and will not significantly affect battery
run time.
• The built-in LED light is designed for
temporary use, and may have less
brightness than a regular traditional
flashlight.
• LED light can be linked to trigger switch
operation by setting with a remote con-
trol. (See page 14.)
Caution
: DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
Содержание EYFGA1A
Страница 149: ... 149 MEMO ...
Страница 150: ... 150 MEMO ...
Страница 151: ...Panasonic Testing Centre Panasonic Europe Ltd Hamburg office Winsbergring 15 22525 Hamburg Germany ...
Страница 152: ...EN DE FR IT NL ES DA SV NO FI PL TR EY9711FGA101 2014 10 Printed in Japan ...