- 8 -
To Set the Belt Hook Angle
Position
1. Slide the belt hook lock lever
1
and
hold it to unlock the belt hook.
2
1
3
. Pull the belt hook
from storing position
2
and set it.
3. Release the belt hook
lock lever to lock the
angle of belt hook.
4. Make sure the belt hook is firmly
locked. Also make sure the belt hook
is firmly locked into position
3
.
• The belt hook can-
not be locked in this
position. Firmly lock
it into position before
use.
To return the belt hook to the storing
position, follow step 1. and . above,
then lower the belt hook.
To secure the lock, follow 3 and 4
above.
To Change the Belt Hook
Location Side
The belt hook can be attached to
either side of the unit.
1. Set the belt hook at storing posi-
tion.
. Loosen the screw turning it coun-
ter-clockwise, using a flat metal or
a flat blade screw driver.
3. Take out the belt hook and insert
into the other side of the slot on the
main unit.
4. Fasten the screw firmly, turning it
clockwise.
The belt hook can be taken out from
the main unit only when it is at storing
position.
Control Panel
(1)
()
(3)
(1) LED light
Pressing
toggles the
LED light on and off.
The light illuminates with
very low current, and it
does not adversely affect
the performance of the
driver during use or its
battery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tem-
porarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
• Power automatically turns off imme-
diately after the battery pack is
installed or when the LED light is on
and the driver has not been used for
5 minutes or more or when the LED
light is turned off and the driver has
not been used for 1 minute or more.
Please depress the switch to operate
the drill again.
This product has the built-in LED light.
This product is classified into “Class 1
LED Product” to IEC (EN) 6085-1:001.
Class 1 LED Product
Caution
: DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
(2) Overheat warning lamp
Off
(normal
operation)
Flashing: Overheat
Indicates operation has
been halted due to battery
overheating.
EY7542(EU).indb 8
2007/07/27 13:59:15
