Panasonic ET-LAV400, Руководство по эксплуатации

Страница: 7 / 10

ENGLISH - 7
Attention
z
The light source lamp is a glass component. If it is hit on a hard object or dropped, breakage
may occur.
Be careful when handling a light source lamp.
z
Grip the handle when you remove the lamp unit. Some parts of the lamp unit are sharpened and
may cause injury.
z
Do not disassemble or modify the lamp unit.
z
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp
may be broken. If replacing the lamp of a projector which has been installed on the ceiling, you
should always assume that the lamp is broken, and you should stand to the side of the lamp
cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when
the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice
immediately.
z
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
Panasonic Connect Co., Ltd. takes no responsibility for any damage or malfunction of the
product resulting from use of lamp units which are not manufactured by Panasonic Connect Co.,
Ltd.
Use only specified lamp units.
z
Do not loosen other than designated screws.
Note
z
A Phillips screwdriver is necessary when carrying out replacement.
Hold the screwdriver firmly.
J
Replacement procedure
1) Switching off the projector and then remove the AC power plug from the wall
outlet.
z
When switching off the projector, make sure to follow the procedures in “Switching Off the
Projector” in the operating instructions of the projector.
z
Wait at least one hour and make sure the lamp unit and surroundings are cool.
2) Use a Phillips screwdriver to loosen the lamp cover fixing screw (one screw)
until it turns freely and remove the lamp cover.
z
Remove the lamp cover by pulling it slowly toward the direction of the arrow.
Lamp cover
Lamp cover fixing screw
How to replace the lamp unit