ENGLISH
- 7
Illustrations in these operating instructions
z
Illustrations of the lamp unit and the projector may vary from the actual product.
Term
z
In this manual, the "Wireless remote control unit" accessory of the projector is referred to as the
"Remote control".
Attention
z
Since the luminous lamp is made of glass, it may burst if dropped or hit with a hard object.
Handle with care.
z
When replacing the lamp unit, be sure to hold it by the handle because its surface is pointed and
its shape is protruded.
z
Do not disassemble or modify the lamp unit.
z
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp
may be broken. If replacing the lamp of a projector which has been installed on the ceiling, you
should always assume that the lamp is broken, and you should stand to the side of the lamp
cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when
the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice
immediately.
z
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
Panasonic Connect Co., Ltd. takes no responsibility for any damage or malfunction of the
product resulting from use of lamp units which are not manufactured by Panasonic Connect Co.,
Ltd. Use only specified lamp units.
z
Do not remove or loosen the screws other than specified ones when replacing the lamp unit.
z
Be sure to reset the lamp counter after replacing the lamp unit.
Note
z
A Phillips screwdriver is necessary when carrying out replacement.
Hold the screwdriver firmly.
Replacing the lamp unit
