Panasonic Connect Co., Ltd.
Web Site : https://panasonic.net/cns/projector/
© Panasonic Connect Co., Ltd. 2022
SS0512AM2042 -PS
Printed in Japan
4) Remove the lamp unit.
Use a Phillips screwdriver to turn the lamp unit
until they turn freely, and then remove the
lamp unit from the lamp case.
Hold the handles of the lamp unit and remove
it.
Do not remove the screws other than the
Lamp unit fixing screws
Lamp unit
Lamp case handle
Guide pins and guide holes
Lamp unit
Lamp unit
handles
5) Attach the lamp unit.
(i) Gently push the new lamp unit into the lamp
case. Install the new lamp unit carefully so
that the guide pins on the lamp case are
inserted into the guide holes on the lamp unit.
• If the lamp unit is not installed properly,
remove it and then gently install it again.
Pushing it in forcibly or exerting excessive
force may break the connector.
(ii) Use a Phillips screwdriver to tighten the
Make sure to attach the lamp unit properly.
6) Attach the lamp case.
Gently push in the lamp case along the
grooves for the lamp case attachment guide
When you secure the lamp case with the
projector installed upward in the vertical
weight. Be sure to hold the lamp case handle
If the lamp case is not installed properly,
remove it and then gently install it again.
Pushing it in forcibly or exerting excessive
force may break the connector.
Make sure to attach the lamp case properly.
Grooves of the guide to attach the lamp case
Guides to attach the lamp case
Lamp case R
Lamp case L
Lamp case fixing screws
Lamp case handles
7) Attach the lamp unit cover
(i) Align the lamp unit cover to the marks of (a)
and (b) ( and
) to attach as shown by
the arrow.
(ii) Close the lamp unit cover in the direction
of the arrow and use a Phillips screw driver
screw (one screw).
Make sure to attach the lamp unit cover
properly.
(a)
(b)
(i)
(ii)
Note
When you place the new lamp unit, the projector
resets the total usage time of the lamp unit
automatically.
When the lamp case is removed or attached,
it will be caught because of the fall-prevention
stopper. This, however, is not a problem.
Attention
After unpacking the lamp unit, discard the
packaging material properly.
