ENGLISH-3
Before replacing the lamp unit
Make sure to turn off the power before replacing the
lamp unit.
When switching off the projector, make sure
to follow the procedures in “Switching off the
projector” (
page 3).
■
Checking the lamp unit to be
replaced
Check the status of the lamp
indicators <LAMP1>/<LAMP2>.
The lamp unit corresponding to the lamp indicator
that is lit in red is required to be replaced.
Main unit operating part
＜
Power indicator
＞
（
ON (G) / STANDBY (R)
）
<Lamp indicator>
(LAMP1, LAMP2)
Power standby
<
> button
<MAIN POWER> switch
Attention
Panasonic shall not be responsible for damages
or malfunctioning of the product due to the use
of other than a Panasonic lamp unit. Use only
Do not use replacement lamp units (for portrait
mode) and normal lamp units together. Check
the product number on the label attached to the
replacement lamp unit.
A replacement lamp unit (for portrait mode) must
be used when installing in a portrait orientation.
Do not install the projector in any orientation other
than portrait when using a replacement lamp unit
(for portrait mode).
Since the luminous lamp is made of glass, it may
burst if dropped or hit with a hard object. Please
handle with care.
Do not disassemble or modify the lamp unit.
When replacing the lamp unit, be sure to hold it
by the handle because its surface is pointed and
its shape is protruded.
The lamp may be burst. Replace the lamp unit
carefully so that the broken pieces of the lamp
glass will not scatter.
The lamp contains mercury. When disposing of
used lamp units, contact your local authorities or
dealer for correct methods of disposal.
Panasonic recommends that the lamp unit be
replaced by a specialized engineer. Contact your
dealer.
Note
A Phillips screwdriver is necessary when
replacing the lamp unit.
The Multi Projector Monitoring & Control Software
in the CD-ROM supplied with the PT-DZ13K
series may not support the Model No. display of
the replacement lamp unit (for portrait mode).
Download the latest version of the software from
“Multi Projector Monitoring & Control Software” on
the Panasonic website (https://panasonic.net/cns/
projector/).
Switching off the projector
When the projector is operating, perform the follow-
ing steps to turn off the projector, and wait until the
lamp unit cools off then make the replacement.
1) Press the power standby < >
button.
2) Press
◀▶
to select [OK], and
press the <ENTER> button.
(Or press the power standby < >
button again.)
Projection of the image will stop, and the
power indicator <ON (G)/STANDBY (R)> on
the projector lights in orange.
(The fan keeps running.)
3) Wait until the power indicator
<ON (G)/STANDBY (R)> of the
projector lights in red (and the
fan stops) for approximately 170
seconds.
4) Press the <OFF> side of the <MAIN
POWER> switch to turn off the
power.
ET-LAD310A(W)_320P(W).indd 3
2013/03/22 11:15:15
