8 - ENGLISH
Mounting procedure (continued)
z
For PT-JW130F series
Rotating fixing
screw
1) Place the projector on a cloth or the like that
has been laid on a flat surface.
2)
Loosen the fixing screw.
z
Loosen the rotating fixing screw of the projector
with the allen wrench (3.0 mm (1/8ʺ) across
flats) supplied with the projector.
Shaft holder
Main unit
3) Change the orientation of the main unit.
z
Loosening the ball joint fixing screw enables
rotation of the shaft holder so that the
orientation of the main unit can be changed.
4)
Tighten the fixing screw.
z
Tighten the rotating fixing screw with the allen
wrench (3.0 mm (1/8ʺ) across flats) supplied
with the projector to prevent the main unit
moving during the mounting work.
Note
z
The rotating fixing screw is a hexagon socket head
screw (M6). Take care because it will come out of
the projector if loosened too much.
Mounting the floor stand to the projector
This section describes mounting the floor stand to the projector.
Main unit
Power supply unit
Bench to adjust height
Soft cloth or alike
Workbench
1) Place the projector on the work bench.
z
Place the power supply unit of the projector on
a work bench that has a soft cloth or the like
laid on it.
z
Also put the main unit of the projector on a
platform laid with a soft cloth or alike to make it
stable.
Attention
z
The projector might turn unstable in this case, so at
least two people are recommended to perform the
mounting work of the floor stand.
