English
Cleaning the shaver
Use the self‑cleaning recharger in temperatures between 15 °C
and 5 °C.
1
1
Insert the appliance plug
into the self-cleaning
recharger.
2
2
Remove the protective
cap and then attach the
shaver.
3
3
Plug in the AC adaptor.
Remove any soap or water on the
shaver if it has been washed with
hand soap or any other detergent.
Turn the shaver off before attaching.
Check that the outer foil is not
deformed or damaged when you
are attaching the shaver.
•
•
•
1
3
2
4
4
Press the SELECT button to select the
course.
Each time you press the SELECT button, the course
changes from “Clean/Dry/Charge” “Dry/Charge”
“Charge”.
The courses start approximately 6 seconds after they
are selected.
The course will be aborted if the power is cut off. In this
case, perform the course again from the beginning.
Do not detach the detergent cartridge or the water tank
as the cleaning liquid may spill causing a malfunction.
•
•
•
•
Course
Time required (guide)
1
Charge
Charge
0 to 60 min
2
Clean/Dry/
Charge
Clean
Dry
Charge
10 min
50 min
(0 min*)
0 to 60 min
It is not possible to change the course after the
“Clean/Dry/Charge” course has started.
•
3
Dry/Charge
Dry
Charge
100 min
0 to 60 min
It is possible to change to the “Clean/Dry/Charge”
course even after the “Dry/Charge” course has started.
•
* When the ambient temperature of the self‑cleaning recharger is
low (approx. 15 °C or lower), the time it takes to dry the shaver
increases.
The Clean or Dry function may stop under extreme low
temperatures (approx. 0 °C or lower). In such a case, the CLEAN
and DRY lamps will blink when the “Clean/Dry/Charge” course is
selected, or the DRY lamp will blink when the “Dry/Charge”
course is selected.
•
