Panasonic ER131, Руководство по эксплуатации, Страница: 6 / 24

6
How to use
<Charging instructions>
1) Set the switch to “0” , and plug
the cord into the clipper body.
(Fig.1)
2) Plug the AC adaptor into an AC
outlet. The charging indicator
lamp will light up. (Fig.2)
3) When charging is completed
unplug the AC adaptor from an
AC outlet. The charging time is 8
hours; 1 full charge will provide
approximately 30 minutes of
continuous operation.
<AC operation>
1) Connect the AC adaptor to the
body in the same way as for
charging, and set the switch to “1”
to use the clipper.
2) If the AC adaptor is connected
while the switch is in the “1”
position, the clipper may not
operate. If this occurs, set the
switch to the “0” position, wait
about 1 minute and then set it
back to the “1” position.
3) Be sure to set the switch “0” to
when finished using the clipper. If
the switch is left in the “1” position,
the rechargeable battery will
become completely discharged,
shortening the life of the battery.
<3/6mm, 9/12mm comb
attachments>
1) The cutting heights are indicated
on the insides and sides of the
attachments, so be sure to look
for the height indication in order
to mount the attachment correctly
for the desired cutting height.
2) To mount the comb attachment to
the clipper, place one side of the
hooks of the comb attachment into
the attachment mounting
B
, then
slide the other side to another
mounting
B
in the direction
indicated with the arrow. (Fig.3)
3) To remove the comb attachment
from the clipper, slide one side of
the attachment off the mounting
B
in the direction indicated with the
arrow. (Fig.4)
<Trimming With No
Attachments>
1) Cut hair by placing the clipper head
directly on the scalp. (Fig.5)
Cutting without an attachment will
trim hair length to 1mm or less.
<Mounting and removal of
the blade>
1) Hold the clipper body with the
“Panasonic” mark facing upward
and push the blade with your
thumb in the direction indicated
by the arrow. When doing this,
catch the blade in your other
hand. Be sure the switch is set to
“0” before attempting to remove
the blade. (Fig.6)
2) To remount the blade, fit the
mounting hook into the blade
mounting on the clipper body and
push in until it “clicks”. (Fig.7)
04̲08̲ER131取説(欧州) 06.02.27 12:58 ページ 6