15
English
16
English
2
1
Press the
button to enter the program
selection mode for Pre-Programs.
(The power will turn off automatically if no operation is performed within
3 minutes after entering the program selection mode.)
1
Press
or
to select a program.
Select one of “DEEP”, “QUICK (8 min)”, “RELAX” and “REFRESH”.
The mark for the currently selected
program will flash.
2
Select a program and press the
button.
1) Put your head on the backrest.
Massage Head
The massage heads will
move slowly upwards with
the unit emitting a beeping
sound.
2) When the massage heads reach the top, an operation to
determine your approximate shoulder position will begin.
[Shoulder checking operation]
Massage Head
The massage heads slowly
lower while performing a
tapping action. (The frame
of
flashes.)
For some sitting positions,
the massages heads may
temporarily reach a
position near the lower
back.
•
USING PRE-PROGRAMS
Pre-Programs characteristics
DEEP
Uses Knead, Soft Shiatsu
and Tap actions to loosen up
the muscles from neck to
lower back.
Recommended for those
with severe stiffness or
who prefer a stimulating
massage.
QUICK (8 min.)
Based on the DEEP
program, this program
concentrates on the areas
which tire easily and is short
at 8 minutes.
Recommended for those
who want a spare-time
massage.
RELAX
Uses less stimulating actions
to relax your body.
Recommended for those
who want to relax with a
gentle massage.
REFRESH
Lowers the massage
intensity gradually and then
raise it to achieve
refreshment.
Recommended for
switching mood.
[Program Selection Mode]
3) A double beep and the flashing of
indicate that the
massage heads are being finely adjusted to the shoulder
position.
[Shoulder Position Adjustment Mode]
<How to adjust>
Press
or
to adjust the
position.
[Each press moves the massage heads
approximately 0.6 in. (1.5 cm).]
4) When the shoulder position is matched, press
to
begin the program.
The program will begin automatically after 15 seconds if the
button
is not pressed.
•
Caution
Keep your head on the backrest
while shoulder position is being
determined.
If the shoulder position cannot be
correctly determined, an error
message (U10) is displayed and
operations are terminated.
Notes
<Target shoulder position>
Too high
Correct position of the massage
head
(The point where the tapping
action should be felt)
Too low
To Customize
To adjust program intensity
Press the – + adjustment buttons.
Content of
display
Intensity
1
2
3
Adjustment
To use the leg/foot massage simultaneously
Press the
button.
(See page 23.)
15-16
2010/01/20 13:28:51
