EBL512 G3 V. 3.0.X
- FIRE ALARM SOLUTIONS OPERATING INSTRUCTIONS
26
8.1.5. USER LEVEL 3A
After the door has been opened with the fire brigade key ("Door open" symbol
in the symbol area), the service / maintenance
personnel have access to level 2A and after log on as “Service personnel” (level 3A), access to all menus, i.e. like level 2C and also
to the following menus:
Same menus as in access level 2C plus the following:
H5 Service
• A1 Calibration of supervised outputs
• A2 Sensitive fault detection mode
• A3 Service mode for COM-loop
• A4 Display current consumption in control unit
• A5 Display current consumption on COM-loop
• A6 Display statistics for communication
• A7 Activate address setting mode for DU
• A8 Setup wireless detectors
• A9 SSD information
H8 Maintenance
• S1 Dis- / Re-connect loop / zone line input
• S2 Acknowledge SERVICE signal
• S3 Clear weekly average
• S4 Test of alarm devices
• S5 Safe shut down of control unit
• S6 Activate address in alarm mode
• S7 Synchronize the control units
• S8 Activate / Reset outputs
H10 Change password (In this case for “Service personnel”.)
8.1.6. ACCESS LEVEL 3B
Used by Service / maintenance / commissioning engineers when a PC (i.e. EBLWin) is to be connected to EBL512 G3 for backup
(upload), download of site specific data (SSD) and/or download of software. EBLWin require an EBLWin key (5094) to be plugged in
the PC.
8.1.7. ACCESS LEVEL 4
Used by manufacturer or by personnel authorised by the manufacturer for re-initialisation (reset) of the alarm counter, change soft
-
ware configurations, on-line status checking, etc. An EBLWin key (5094)
is required to be plugged in the PC.
