13
DAILY USER´S MANUAL
•
EBL128 VERSION 2.2.X
•
DOCUMENT NUMBER: MEW01786
•
REVISION: 1
9.
PRESENT SYSTEM STATUS (H4)
Information only.
a)
Log on to the c.i.e.
b)
Navigate to menu H4.
c)
Press "A". The sub menu consists of a list (U1 - U8) in which you can scroll. U1 is displayed.
d)
Select a sub menu and press “A”.
9.1.
SUB MENU LIST (U1 – U8)
U1
Disablement
Disablements, except "disablements by time channel", are
displayed.
Indicated by LED "Disablements".
U2
Disablement by time channel
Only "disablements by time channel", are displayed.
Indicated by LED "Disablements", also the LEDs "Fault /
Disablements Alarm devices" and/or "Fire brigade tx".
U3
Sensor values
Use the keypad to specify the "Start sensor".
The default zone-address 00-00 can be used.
Press "A". This is a list in which you can scroll.
NOTE!
For most detectors additional information can be shown by
using
.
U4
Sensors activating service
signal
Indicated by LED "Service".
NOTE!
Service signal is acknowledged via menu H8/S2, which
require log on with a password for access level "Service
personnel".
U5
Technical warning
If one or more technical warnings are activated in the system, the
technical warning symbol
[i]
is shown.
U6
Event log
Use the keypad to select event log:
- 0 = Alarm.
- 1 = Interlocking.
- 2 = General.
Press "A". This is a list in which you can scroll.
U7
Version and alarm counter
- Version: The EBL128 software / firmware version.
- Alarm counter The alarm counter is increased with "1" every time
the c.i.e. enters the real "fire alarm condition".
