Panasonic DP-3530, Руководство по обслуживанию

Страница: 627 / 858

627
JAN 2006 Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
f. Measure the winding amount (shift) of the stack of sheets, and compare this amount with the
standard amounts.
• This amount should be measured at the center of the paper leading edge.
Fig. 7-009
g. If the amount is within the standard, turn the Copier OFF, and then set all bits of SW3 to OFF. If the
amount is outside the standard, perform the following.
h. Turn the Copier OFF, and set SW3 on the Finisher Controller PCB as indicated. If EEPROM (Q2) on
the Finisher Controller PCB has been replaced, proceed to step j).
Fig. 7-010
i. Turn the Copier ON, and then press SW2 on the Finisher Controller PCB.
• The current setting values are displayed at LED1.
The adjustment width is 0.72 mm for each N=1.
Table 7-001
j. Turn the Copier OFF, and then set SW3 on the Finisher Controller PCB as indicated.
Fig. 7-011
Adjustment value 0 Lights for 1 second (once)
Adjustment value +N Blinks (lights for 0.2 second) for N times.
Adjustment value –N
Lights for 1 second (once), and blinks
(lights for 0.2 second) for N times.
1st sheet
Paper exit direction
1st sheet and 2nd sheet: 0
±
1mm
1st sheet and 3rd sheet: 4mm or less
2nd sheet and 3rd sheet: 4mm or less
3rd sheet
2nd sheet
1
ON
2 3 4 5 6 7 8
1
ON
2 3 4 5 6 7 8