Auto-Setup with RF cable (Aerial cable)
(Automatic tuning)
!
Turn on your television set.
!
With the
Stand-by/on switch
turn on the DVD Recorder. Automatic tuning for all
available TV stations begins. Approximate duration is 5 minutes.
!
After Automatic tuning has finished, press
RETURN
. The Owner ID screen will appear.
- While Auto-Setup is running the first digit of the DVD Recorder display will flash. After
a while it will stop flashing and the RF output channel number will be displayed.
- Select an unused channel pre-set on your TV and tune it to the RF output channel
number shown on the DVD Recorder display (or until you can clearly see the Auto
Setup screen). Store the new video playback channel (refer to the instructions for your
TV).
In some cases, the RF output channel may interfere with the TV stations transmitted in
your area. This may prevent you from seeing the On-Screen Display clearly. Please see
page 20 for removing the interference before restarting Auto-Setup (page 72).
!
Press
to set the correct time and date and press
ENTER
to finish this setting.
If the clock setting menu appears
(Auto clock set was not possible due to a weak signal)
Mind that a wrong date or time will influence the programmed recording of TV
programmes (don't forget to change summer time and winter time).
19
DVD Display
Clock
Off
Automatic
0
00
00
1
1
2005
:
:
.
.
Time
Date
CHANGE
ENTER
RETURN
Clock cannot be set automatically.
Please set the clock manually.
ENTER: store RETURN: leave
SELECT
0
9
No
Auto-Setup
Ch
4
Suche Sender, bitte warten.
RETURN: abbrechen
35
Auto-Setup in progress, please wait.
RETURN: to abort
RETURN
You can complete the Owner ID now or skip this step and do it later. To do it later, press
the
RETURN
button. Your DVD Recorder is now ready to use.
!
To set the Owner ID now, use and press the
Numeric
buttons or
to enter a
four-digit PIN number. Press , to correct the digit.
!
Make sure that you will remember the PIN number (make a note of it).
!
Press the
ENTER
button twice to confirm.
!
Enter the [Name], [House No] and [Postcode] in the same way, using
.
!
Press the
ENTER
button to confirm each entry.
!
Press the
RETURN
button to leave the Owner ID screen.
!
You will now see the TV picture. Your DVD Recorder is now ready to use.
Owner ID
Owner ID
RETURN
Name
House No.
Postcode
PIN number
* * * *
RETURN : leave
* * * * * * * * * * * * * *
* * * * * * * * * * *
* * * * * * * * * * *
