7
RQT7540
G
e
tt
in
g
st
ar
te
d
≥
When there is no 21-pin Scart terminal on the television (
➡
page 8)
≥
Change the “AV2 Input” setting to match the output from a satellite receiver and set the “AV2 Connection” setting to “Normal” in the SETUP
menu (
page 41) after tuning is completed (
∫
To view satellite programmes
Press [INPUT SELECT] to select the input channel “A2” for the satellite receiver or put this unit in standby mode.
∫
RGB
This refers to the three primary colours of light, red (R), green (G), and blue (B) and also the method of producing video that uses them. By
dividing the video signal into the three colours for transmission, noise is reduced for even higher quality images.
Connecting a television with 21-pin Scart terminal and Satellite receiver
R - AUDIO - L
VIDEO
P
R
S-VIDEO
R - AUDIO - L
VIDEO S-VIDEO
OPTICAL
OUT
AV
4
I
N
RF IN
RF OUT
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
COMPONENT
VIDEO OUT
(NTSC:480P/480I,
PAL:576P/576I)
P
B
Y
AV1 (TV)
AV2 (DECODER/EXT)
AC IN
AV IN
VHF/UHF
RF IN
DVD/VCR
2
3
1
1
4
4
To the
aerial
Aerial
lead
Cooling fan
RF
coaxial lead
AC mains lead
Connect only after all other
connections are complete.
To household mains socket
(AC 220–240 V, 50 Hz)
Fully wired 21-pin
Scart lead
Fully wired 21-pin
Scart lead
AV1 terminal
If your television is equipped with RGB input
capability, by connecting with a fully wired 21-pin
Scart lead you can see video using RGB output on
this unit (
➡
below).
To output in RGB select “RGB (without component)”
from “AV1 Output” in the SETUP menu (
Television’s
rear panel
Satellite receiver’s rear panel
This unit’s rear panel
indicates included accessories.
indicates accessories not included.
are required connections. Connect in the numbered order.
BE SURE TO READ THE CAUTION FOR THE AC MAINS
LEAD ON PAGE 2 BEFORE CONNECTION.
7540en.book 7 ページ 2004年2月10日 火曜日 午後12時58分