13
RQT7540
G
e
tt
in
g
st
ar
te
d
[For]the[United]Kingdom]only[
In some cases, interference (lines or patterning) or a very poor
picture may appear on the TV screen when this unit is connected.
≥
When connecting to a television with RF leads only
(
Follow the steps below to change the video playback channel (RF
output channel) to remove the interference.
≥
When connecting to a television with a fully wired 21-pin
Scart lead (
page 7).
Perform steps 1, 2 and 4 to stop the RF output. In step 2, press [0]
to select “
ss
”.
1
Press [FUNCTIONS] for more than 5
seconds.
2
Press [
W X
CH] to select a channel
number, which differs by 2 or 3 from
the present channel number.
e.g. If the original channel number was 28, enter 31.
The test pattern screen disappears.
3
Re-tune your TV until you receive the
test pattern screen.
If you can’t see the test pattern screen clearly, repeat step 1
and 2 to select RF output channel again
4
Press [ENTER] to finish this setting.
This unit doesn’t recognise Video Plus+ numbers for Satellite
stations or Cable TV stations.
The following operation also allows you to use Video Plus+
numbers to make timer recordings for satellite and cable TV
stations. As the settings indicated below are dummy timer
recordings, delete them in step 6.
Preparation
Turn on the Satellite receiver(s) or Cable TV box.
Select a correct station.
1
Press [VIDEO Plus+].
2
Press the numbered buttons to enter
a VIDEO Plus+ number for a satellite
station (e.g. Sky One) or Cable TV
station.
Press [
2
] to move back to correct a digit.
3
Press [ENTER] .
“-- ---” will appear under “Name”.
4
Press [
3
,
4
] to select the channel or
AV input that is to be used for
recording from the satellite station or
Cable TV station.
5
Press [ENTER].
The channel or AV input corresponding to the VIDEO Plus+
number is memorised.
Repeat steps 1
s
5 above until you have set dummy timer
recordings for each of the satellite stations or Cable TV
stations that you will make VIDEO Plus+ recordings from.
6
Press [
3
] to select each programme
that you have just set and press
[
¢
CANCEL] to delete it from the
timer recording list.
To exit the screen
Press [RETURN].
Removing Interference
TV screen
Picture with interference
RF OUTPUT CHANNEL
DVD
CH : 28
SELECT
ENTER
RETURN
RF output channel number appears.
Test pattern screen appears.
Unit’s display
TV screen
RF OUTPUT CHANNEL
DVD
CH : 31
SELECT
ENTER
RETURN
Clear picture
VIDEO Plus+ numbers for Satellite/
Cable TV stations
1:58 SP
VIDEO Plus
+
Remain
12:53:00 15. 7. TUE
Enter
VIDEO Plus+ Number by using 0-9 key.
Mode
Stop
Start
Name
Date
1:58 SP
TIMER
RECORDING
Remain
12:54:00 15. 7. TUE
PDC
Programme Name
20:00
19:00
15/ 7 TUE
SP
OFF
SP
OK
20:00
19:00
AV2
15/ 7 TUE
01
Mode
Disc
space
Stop
Start
No.
Name
Date
1:58 SP
TIMER
RECORDING
Remain
12:55:00 15. 7. TUE
New Timer Programme
OFF
PDC
7540en.book 13 ページ ２００４年２月１０日 火曜日 午後１２時５８分
