Panasonic DMP-BDT220GA, Руководство по обслуживанию

Страница: 45 / 99

45
9.4.2. Adjustment
9.4.2.1. [Drive] Input OPU-QR code(72)
1. Input 72 with the remote control's numeral keys in the service mode.
The FL tube display “DQR__”(__ is blank) at this time. QRcode scroll display is in the input state.
2. Input QRcode with remote control:
The FL is displaying the input numeric from the left.(Use "*" to display the digits needed to enter)
Input the first six digits: “******” The digit has not been entered.
“1*****” The 1st digit has been entered.
“12****” The 2nd digit has been entered.
“123456” The 6th digit has been entered.
Input the remaining 5 digits:
“*****” The 7th digit has not been entered.
“7****” The 7th digit has been entered.
“78***” The 8th digit has been entered.
(* The QRcode input operation cannot be cancelled, when the 11 digits are not input totally.)
(* The input operation will be cancelled by entering "00000000000".)
3.Input the 11 digits totally, then the 11 digits are registration QRcode.
The registration status will display on the FL tube.
When register successful: “DQR_OK”
When register fail: “DQR_NG”
4. Release command: Press the numeral keys [10][10] to end the input mode.
For Example of QR-CODE:
9.4.2.2. [Drive] Adjustment value initialization(71)
When the projector is being manufactured in the factory, the drive adjustment value is initialized.
In the service mode, enter 4 digits password (
)after numeral keys are input on the remote control, then initialization
starts.
If password is entered by mistake, it will return to initial status in the service mode (SERV_).
9.4.2.3. In the Case of Necessity the Adjustment (The above initialization)
1. When the OPU is replaced.
2. When the Drive unit is replaced.
3. When the Digital PCB is replaced.
D P When a digit is entered, it is displayed in (4 digits) (Blank shows when no password is being input)
D I N I
(Enter Input a correct password of 4 digits), then initialization is performed.
D I N I O K When adjustment value is initialized and auto adjustment is ended normally.
D I N I N G When adjustment value is initialized and automatic adjustment is ended abnormally.