27
9.2.2.
Tray
1. Perform the step “9.2.1. Upper base ass’y”.
2. Insert the Eject pin into the hole of the bottom side, and
slide it to the direction of arrow until it can be.
3. Pull the Tray to the direction of arrow until it can be.
4. Insert the Eject pin into the hole of the Tray at 45 degrees,
and lean it to the direction of arrow with pushing the dot-
ted point of the tray forward.
Then the one side of the tray is come off from the Drive.
5. Insert the Eject pin into the Tray as below figure, lift up the
lever using the Eject Pin while pushing the dotted point of
the Tray.
And remove the Tray.
Содержание DMP-BD50EG
