
VQT1X57
112
Others
[MEMORY CARD PARAMETER ERROR]
>
Use a card compatible with this unit. (P16)
•
You can only use an SDHC Memory Card if using cards with 4 GB or more capacity.
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
•
An error has occurred accessing the card.
>
Insert the card again.
>
Insert a different card.
[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
•
It has failed to read or write data.
>
Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
•
The card may be broken.
>
Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
When you set the picture quality to [
], [
] or [
], we recommend using a high-speed
card with “10MB/s” or greater displayed on the package.
•
In the event that it stops even after using a “10MB/s” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P26).
•
Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording
may stop in the middle.
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used. (P98)
>
Format the card after saving necessary data on a PC etc. (P26) If you execute [NO.RESET]
in the [SETUP] menu after formatting, the folder number is reset to 100. (P25)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
•
The AV cable is connected to the camera.
>
Press [MENU/SET] if you want to delete this message at once.
>
Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P25)
•
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P97, 99)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
•
The printer cannot print.
>
Check the printer.
[NO BATTERY POWER REMAINS]
•
The remaining battery power is low.
>
Charge the battery.
[THIS BATTERY CANNOT BE USED]
•
The battery cannot be recognized by the camera.
>
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
•
The battery cannot be recognized as its terminal is dirty.
>
Remove any dirt etc. from the terminal.
DMC-FX48P_PC~VQT1X57_eng.book 112 ページ 2008年12月26日 金曜日 午後6時25分