Panasonic Digital Business System - Installation Manual
March 1997
Issue 5
25
With the introduction of version 4 software basic hotel features were added to the DBS and further additions made
to the call logging output. These indicate alarm setting and cancelling for extensions by the operator, extension
and exchange line costs and service data output.
Examples of these new outputs are shown below.
EXT..COL..Start.....Durat...........Dial-Data..........Account....Charge
222..A...09.05.16.09.19:15..S
Alarm set
222..A...09.05.16.09.19:15..C
Alarm cancelled
222..A...09.05.16.09.19:15..A
Alarm answered by 222
222..E...09.05.16.09.19:15..N
Alarm not answered
Account.data.EXT.222.:.000052.00
Extension call charges
Account.data.TRK03...:.00563.20
Exchange line call charges
200.....09.05.16.52...........#222#123*00
Special service data
Figure 23 - v4.x Additional Output Examples
The introduction of version ISDN 1.0 added the following condition code options.
Condition Code
Meaning
i
Incoming DASS II call
o
Outgoing DASS II call
Z
Incoming DASS II DDI call
Table 8 - Additional Condition Codes In Version ISDN 1.0 Software
With version 4.1 and ISDN 1.1, the call logging output is updated to show which have been held or transferred.
The new condition codes are shown below:
Condition Code
Meaning
H
Call has been held and retrieved or recalled. The time field shows when
the call was retrieved and the duration will shown how long it was held
for. If the caller cleared when on hold the line number will be preceded
by a ‘*’. Type of hold is not detected.
T
Call has been transferred or held and retrieved or recalled at some
point. This will print at the end of the call where the start time is the time
it was transferred or retrieved and the duration is the time since it was
transferred or retrieved.
Table 9 - Additional Condition Codes In Versions 4.1 And ISDN 1.1
When determining the history of the call the extension number and line number data must also be compared.
T will also be output if a conference call is initiated and the initiating extension drops out.
Dialled data is repeated on all records for a call, the ringing time will appear on the first record only and the
account code will print for each record until the call is transferred at which point it will clear. The call cost from
meter pulse detection will be for the portion of the call covered by each individual record. DASS II call charge data
will only be output when the call is finally cleared.
