Panasonic DC-S1P, Руководство по обслуживанию

Страница: 8 / 66

8
3.3.1.3. About Simplicity flange back adjustment
* “Flange back” is the distance from the lens mount level to the Image Sensor level.
When turning the image sensor unit mounting screw even a little or removing, the “simplicity flange back adjustment” is needed.
Perform the “simplicity flange back adjustment” according to contents described in “10 Measurements and Adjustments” section of
this service manual.
3.3.1.4. About Shutter Mount Base Unit (Ref. 11)
Before exchanging the “shutter mount base unit”, confirm that the symptom and/or phenomenon is not due to the setting of func-
tions.
Important:
After replacing the shutter mount base unit, the shutter mount base unit data has to be stored to the unit.
The shutter mount base unit supplied as service parts has affix the label of own configure data.
By inputting second line to fourth line of these data into the adjustment software and writing these data to Flash-ROM (IP2201),
the shutter adjustment becomes needless.
Refer to the adjustment instruction in the adjustment software for details.
3.3.1.5. About Firmware Update
The procedure for firmware updating is partly changed for this camera.
For the specific procedure, please confirm the contents that are released at the same time as the firmware for updating is released
on the HP of firmware downloading.
3.3.2. About Flexible Cable and Connector
Do not touch carelessly so that the foreign body should not adhere to the terminal part of flexible cable and connector.
Wipe off with a clean cloth and the cotton bud, etc. when the terminal part is dirty.