Panasonic CZ-RWST3, Руководство по эксплуатации

Страница: 15 / 202

9. Using the Remote Control
EN-13
EN
• Point the transmitter of the remote control at the receiver. When the signal is received correctly it will
beep once. (It beeps twice only when the unit starts operating.)
• The signal can be received at a distance of about 6 meters. This distance should be used only as a
guide. It depends on battery strength.
• Make sure nothing is between the remote control and the receiver that could block the signal.
• Do not leave the remote in direct sunlight, where the wind from the air conditioner can blow directly
on it, or near any other heat source.
• Take care not to drop, throw or wash the remote control with water.
• The signal from the remote control may not be received in rooms with rapid start fl uorescent
lighting, inverter lights, plasma displays, LCD televisions (monitor), etc. For more information, please
contact the dealer where the product was purchased.
Wall Mount Use
• Press from the location you wish to mount the remote and
make sure the signal is received correctly.
• Pull the remote control forward to remove it.
10. For Best Results
Don’t get the remote control too far away from the receiver.
This may cause a malfunction.
Be sure to keep the remote control in the same room as the receiver.
Point the remote control at the receiver.
When the signal is received correctly it will beep one time.
Avoid locating the remote control where it is covered, such as behind a curtain.
Keep it out in the open.
1
2
Fasten the remote
control mount with
screws. Fitting the remote
control in the
mount.
Remote control
mount
Press
Put in
OI_072023_all.indb EN-13 OI_072023_all.indb EN-13 2014/12/19 10:24:11 2014/12/19 10:24:11