Panasonic CS-ME7CB1P, Руководство по обслуживанию

Страница: 34 / 69

OPEN
Is there any gas leakage at
flare nut connections?
Is the power supply voltage
complied with rated value?
Is there any abnormal sound?
Is the cooling / heating operation
normal?
Is the thermostat operation
normal?
Is the remote control’s LCD
operation normal?
Has the heat insulation been carried
out at flare nut connection?
Is the connecting cable being fixed
to terminal board firmly?
Is the connecting cable being
clamped firmly?
Is the drainage ok?
(Refer to “Check the drainage”
section)
Is the earth wire connection
properly done?
ENGLISH
MATSUSHITA ELECTRIC INDUSTRIAL CO., LTD.
Web Site : http://www.panasonic.co.jp/global/
F612424
PRINTED IN JAPAN
CHECK ITEMS
The below operations will be performed by pressing the “AUTO” switch.
1. AUTO OPERATION MODE
1. The Auto operation will be activated
immediately once the “AUTO” switch is pressed.
2. TEST RUN OPERATION (FOR PUMP
DOWN/SERVICING PURPOSE)
The Test Run operation will be activated if
the “AUTO” switch is pressed continuously for
more than 5 sec. to below 8 sec..
1. A short beep sound will occur at the fifth sec.,
in order to identify the starting of Test Run
operation.
• When installing two air conditioners in one room, each air conditioner can be
synchronized to the remote control.
In order to operate separately, open the rear cover of one of the remote control and set
to “B”.
Setting the air conditioner unit to “B”
1. Press the “AUTO” switch for about 11 to 15 seconds. When you hear three short beeps,
release the switch.
1. Note: you will hear one short beep in about 5 seconds, and then two short beeps in about
8 seconds.
2. Press again the “AUTO” switch within 60 seconds. Every press the “AUTO” switch, you
will hear a short beep. When you hear eventually a long beep, stop pressing the
“AUTO” switch , which achieves “B” setting.
1. If you stop pressing the “AUTO” switch midway at the short beep, this will achieve
“A” setting.
3. After 60 seconds or longer of the above setting, use the “B” set remote control to confirm
successful operation.
Set “B” on the remote control.
This can be achieved by cutting
the jumper wire of the remote
control with a cutter.
Changing the remote control transmission code
AUTO SWITCH OPERATION
Remote control
Give two cuts.
Side view of jumper
The disconnected jumper
wire is “B” setting.
Jumper wire
“DRAIN TEST”
switch
“AUTO” switch
CS
-M
E
7C
B
1P
/
C
S
-M
E
10CB1
P
/
CS
-M
E
12CB1
P
/
CS
-M
E
14CB1
P
/
CS
-M
E
10CD3
P
/
CS
-M
E
14
CD3P
34