Panasonic CS-HE12PKD, Руководство по эксплуатации

Страница: 6 / 52

6
Indicator
ECONAVI
To optimise energy saving
MODE
To select operation mode
AUTO - For your convenience
HEAT - To enjoy warm air
COOL - To enjoy cool air
DRY - To dehumidify the environment
MILD DRY
COOLING
To improve humidity and
moisture level
• This operation reduces air dryness and provides
you with a comfortable living environment
during COOL mode only.
• When vertical air fl ow direction is set to AUTO, it
stops at lower position to avoid cold air contact.
However, you can adjust the louver direction
manually.
POWERFUL/
QUIET
To switch between
powerful & quiet
QUIET POWERFUL NORMAL
POWERFUL: To reach temperature quickly
POWERFUL
• This operation stops automatically after 20
minutes.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces air fl ow noise.
How to use
Auto OFF/ON button
AUTO
OFF/ON
Use when remote control is a malfunction occurs. Raise the front panel:
1. Press the button once to use in AUTO mode.
2. Press and hold the button until you hear 1 beep, then release to use in forced
COOL mode.
3. Repeat step 2. Press and hold the button until you hear 2 beeps, then release to
use in normal COOL mode.
4. Repeat step 3. Press and hold the button until you hear 3 beeps, then release to
use in forced HEAT mode.
• Press the button again to turn off.
Human activity
sensor
Sunlight sensor and
remote control receiver
TIMER
AUTO COMFORT
NANOE-G POWERFUL QUIET POWER
(Green) (Green) (Blue) (Orange) (Orange) (Orange) (Green)
FAN SPEED
To select fan speed
(Remote control display)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
AUTO
COMFORT
MODE
POWERFUL/
QUIET
TEMP
OFF/ON
TIMER
SET
CANCEL
ON
OFF
1 2 3
AIR SWING
FAN SPEED
MILD DRY
COOLING
SET CHECK CLOCK RESET
AC RC
MILD
DRY
FAN
SPEED
AIR
SWING
AUTO
HEAT
COOL
DRY
ECONAVI
NANOE-G
/
TEMP
OFF/ON
TIMER
SET
CANCEL
ON
OFF
1 2 3
CHECK CLOCK
Remote control display
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
Not used in normal
operations.