Panasonic CS-E9PD3EA, Руководство по обслуживанию

Страница: 58 / 112

58
13.1.4 IPM (Power transistor) Prevention Control

Overheating Prevention Control
1 When the IPM temperature rises to 120°C, compressor operation will stop immediately.
2 Compressor operation restarts after three minutes the temperature decreases to 110°C.

DC Peak Current Control
1 When electric current to IPM exceeds set value of 20.23 ± 5.0 A (for E9PD3EA), 30.0 ± 5.0 A
(for E12PD3EA), the compressor will stop operate. Then, operation will restart after three minutes.
2 If the set value is exceeded again more than 30 seconds after the compressor starts, the operation will
restart after two minutes.
3 If the set value is exceeded again within 30 seconds after the compressor starts, the operation will restart
after one minute. If this condition repeats continuously for seven times, all indoor and outdoor relays will be
cut off.
13.1.5 Compressor Overheating Prevention Control
Instructed frequency for compressor operation will be regulated by compressor top temperature. The changes of
frequency are as below figure.
If compressor temperature exceeds 107°C, compressor will be stop, occurs 4 times per 20 minutes, timer LED will be
blinking (“F97” is to be confirmed).
13.2 Protection Control For Cooling & Soft Dry Operation
13.2.1 Outdoor Air Temperature Control
The compressor operating frequency is regulated in accordance to the outdoor air temperature as shown in the
diagram below.
This control will begin 1 minute after the compressor starts.
Compressor frequency will adjust base on Outdoor Air Temperature.