Panasonic CS-E9PD3EA, Руководство по обслуживанию

Страница: 45 / 112

45
B. IF REMOTE CONTROLLER CABLE IS EXPOSED
1 Install the remote controller lower case to the wall with the two accessory screws .
2 Fasten the screws properly until screw head is lower than the rib and reach the base of remote controller
lower case to ensure they do not damage the PCB inside the remote controller .
3 The feeding-out direction for the remote controller cable can be either via top, left or right side.
4 Use nipper to cut a notch at the upper case. (Select the intended feeding-out position)
5 Route the remote controller cable inside the lower case in accordance with the intended feeding-out
direction. (Refer to the illustration at below).
6 Insert firmly the connector of remote controller cable to connector (CON1) in the upper case circuit board.
(Refer to the illustration at below)
7 Secure the remote controller upper case to the lower case with the tabs provided.
11.1.4 CONNECTING THE DRAIN PIPING

Lay the drain piping so as to ensure drainage.

Use a locally purchased VP20 general rigid PVC pipe (outer diameter ø26) for the drain piping and firmly
connect the indoor unit and the drain piping using PVC adhesive to ensure that no leakage occurs .

Drain piping located indoor should always be insulated by wrapping with locally purchased insulation (foamed
polyethylene with a thickness of 10 mm or more).

The drain piping should have a downward gradient (1/50 or more) and should be secured by using pipe hanging
equipment to avoid creating hills or traps partway.

Should there be any obstacle preventing the drain piping from being extended smoothly, the drain piping can be
raised outside of the main unit as shown in the illustration below.
Strictly do not install and extend the drain piping from the main unit drain water outlet horizontally or upward or raised it 20 cm or more.
Doing so may result in poor drainage or drain motor failure.