Panasonic CS-E12NKEW, Руководство по обслуживанию

Страница: 75 / 189

75
š
Remote Control Receiving Sound
o
Normal Operation
Î
nanoe-G Operation : Beep
o
Nanoe-G Operation Î Normal Operation : Beep
o
Stop Î nanoe-G individual Operation : Beep
o
Nanoe-G individual Operation Î Stop : Long Beep
š
Power failure
o
During nanoe-G individual operation, if power failure occurs, after power resumes, nanoe-G individual
operation resumes immediately.
o
During combination operation, if power failure occurs, after power resumes, combination operation resume
immediately.
o
nanoe-G operation status is not memorized after OFF the unit. After OFF the unit, when the operation is ON
again, air conditioner operates without nanoe-G operation.
š
nanoe-G check mode
o
To enable nanoe-G check mode, during nanoe-G operation ON:
o
If there is abnormal discharge, nanoe-G indicator blinks immediately.
š
Error detection control
When nanoe-G indicator blinks, it indicates error listed below:
o
nanoe-G connector at main PCB open
ƒ Judgment method
š
During nanoe-G operation, nanoe-G connector at main PCB is opened.
ƒ Troubleshooting method
š
Connect the connector or stop operation to cancel the blinking
o
Abnormal discharge error
ƒ Judgment method
š
During nanoe-G operation, the nanoe-G system has abnormal discharge due to short-circuit caused
by water or dust adhesion and so forth, with Lo-feedback voltage (at microcontroller).
š
When abnormal discharge occurred, every 30 minutes the unit supplies power to the nanoe-G
system.
š
When abnormal discharge occurs for 24 times continuously, nanoe-G indicator blinks.