10
Preparation
CQ-C8403N
Cancellation of demonstration screen
Remote Control Preparation
Preparation Before Initial Use
Pull the insulation film out
from the backside of
remote control gently.
Battery Replacement
q
w
q
Remove the battery holder
with the remote control unit
placed on a flat surface.
q
Stick your thumbnail into
the groove, and push the
holder in the direction of
the arrow, and at the
same time.
w
Pull it out in the direction
of the arrow using a
tough pointed object.
2
3
w
Put a battery in the case
with (+) side facing up.
e
Put the case back.
Tough pointed object
Back side
Insulation film
Warning
Keep batteries and insulation film out of reach of
infants. If an infant ingests a battery, please seek
immediate medical attention.
Cautions
¡
Remove and dispose of an old battery immediately.
¡
Do not disassemble, heat or short a battery. Do not
throw a battery into a fire or water.
¡
Follow local regulations when disposing of a battery.
¡
Improper use of a battery may cause overheating, an
explosion or ignition, resulting in injury or a fire.
Note:
Battery Information:
Battery Type: Panasonic lithium battery (CR2025)
(Included in the remote control)
Battery Life: Approximately 6 months under normal use
(at room temperature)
For the first use, the following screen may appear
repeatedly.
1
Set your car's ignition switch to the ACC
or On position.
2
Press
[SRC]
(
PWR:
POWER).
The demonstration screen appears.
3
Press
[MENU]
to display the menu
display.
For using the remote control, hold down
[SEL]
(MENU)
for 2 sec. or more.
4
Press
[
]
]
or
[
[
]
to display the
DISPLAY menu.
5
Press
[
{
]
or
[
}
]
to select
“DEMONSTRATION”.
6
Press
[BAND]
(
SET
) to select “OFF”
7
Press
[MENU]
.
For using the remote control, hold down
[SEL]
(MENU)
for 2 sec. or more.
Note:
This unit is operable as usual even if the
demonstration screen is activated. The demonstration
screen automatically appears if no operation is executed
for 1 minute.
