CQ-2130U
18
Installation
(Continued)
❐
Preparation
❐
Installation Hardware
Warning:
If your vehicle is equipped with air bag
and/or anti-theft systems, specific procedures may
be required for connection and disconnection of the
battery to install this product.
Before attempting installation of this electronic com-
ponent, contact your vehicle dealer or manufacturer
to determine the required procedure and strictly fol-
low their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY
RESULT IN THE UNINTENDED DEPLOYMENT OF
AIR BAGS OR ACTIVATION OF THE ANTI-THEFT
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE
AND PERSONAL INJURY.
Caution:
Various settings that have been stored in
the memory in other on-board equipment (vehicle
navigation etc.) may be lost if the battery terminals
are disconnected.
Therefore, we recommend to make a record of or to
back up the settings before disconnecting the termi-
nals.
After completing installation of the main unit, set the
equipment again according to the record.
• Disconnect the cable from the negative
battary ter-
minal (see warning and caution below).
• Remove Mounting Collar
q
from the main unit tem-
porarily, which are already mounted at shipment.*
• Unit should be installed in a horizontal position with
the front end up at a convenient angle, but not more
than 30˚.
❐
Dashboard Installation
Installation Opening
This unit can be installed in any dashboard having an
opening as shown below. The dashboard should be
3/16” (4.75 mm) – 7/32” (5.56 mm) thick in order to be
able to support the unit.
Q’ty
Item
No.
Diagram
q
1
Mounting Collar*
Plain washer (5mmø)
w
2
Spring Washer (5mmø)
e
2
Hex. Nut (5mmø)
r
2
Rear Support Strap
t
1
Hex. Bolt
(5mmø
×
25 mm)
y
1
Toothed Lock Washer
(5mmø)
u
1
Removal Tool
(U-shaped)
i
2
Antenna Connector
o
1
Mounting bolt
(5 mmø)
q
Mounting collar
Rear support bracket
(provided on the vehicle)
Rubber cushion (option)
(a) Using the rear support strap
t
(b) Using the rubber cushion (option)
