7
E
Center Holder
Eject Button
Label side up
1
Power on your computer
2
Open the disc tray
Press the eject button and slowly pull out the tray.
3
Place a disc
Place the disc with the label facing upward in the
drive and push down until the center holder clicks.
<Removing a disc>
Place a finger on the center holder and lift up on the
edge of the disc.
4
Close the disc tray
Close the tray without touching the eject button.
If the vibration of the CD-ROM drive is excessively high, use the Setup Utility to re-
duce the CD-ROM drive speed by setting it to [Low].
NOTE
Power-saving Mode
If the CD-ROM drive has not been accessed within 30 seconds, the drive motor will auto-
matically shut down to reduce the power consumption. When the CD-ROM drive is ac-
cessed once again, the power of the drive motor is turned on. However, approximately 30
seconds are required until data is actually read from the disc.
Setting a Disc
