Panasonic BT-LH910G, Руководство по эксплуатации

Страница: 34 / 76

34
Main Menu
(continued)
SYSTEM CONFIG
The underlined values are factory preset setting values.
Sub menu Settings Description
SUB WINDOW
FULL
PART Selects sub-window type.
<FULL> Reduces the entire images for both input signals and
places them side by side.
<PART> Cuts out the center of the images for both input signals
and places them side by side (the images are shown at
their original size).
MENU POSITION CENTER
LB
RB
RT
LT Positions the on-screen menu.
<CENTER> Center of the screen
<LB> Left Bottom <RB> Right Bottom
<RT> Right Top <LT> Left Top
STATUS
DISPLAY
*
1
CONTINUE
3SEC OFF
OFF Sets the display state of the operating status display (page 18).
<CONTINUE> Displayed at all times
<3SEC OFF> Displayed for 3 seconds after a status change.
*
2
<OFF> Not displayed.
BATTERY
REMAIN
OFF
ON Selects whether DC power supply voltage and battery level
display.
<OFF> Not displayed.
<ON> Displayed.
WARNING
VOLTAGE *
3
TYPE1
TYPE2 Sets the near end warning voltage for the battery level display.
<TYPE1> Select this when you will mainly use an external DC
power supply. Near end is approximately 11.3 V.
<TYPE2> Select this when you will mainly use a battery. Near
end is approximately 13.3 V.
SETUP LOAD *
3
USER5 *
4
USER4
*
4
USER3
*
4
USER2 * 4
USER1 *
4
FACTORY
Loads saved factory defaults (FACTORY) or user data (USER1 -
USER5) (page 23) .
After loading user data, the screen displays the signal selected
before user data was loaded.
SETUP SAVE USER5
USER4
USER3
USER2
USER1
Up to 5 sets of user data can be saved (page 23).
They save menu settings and adjustments made with the picture
adjusting knob except “SETUP SAVE/SETUP LOAD.”
POWER ON
SETUP
USER5
USER4
USER3
USER2
USER1
FACTORY
LAST
Selects the settings used when the power is turned on.
<LAST> Starts in the mode used when the power was
last turned off.
<FACTORY> Starts up using the factory defaults.
<USER1 - 5> Starts up using USER registered settings.
When PIXEL to PIXEL, operation is with CONTINUE regardless of the setting.
* 1
When PIXEL TO PIXEL/3D assist mode, the 3SEC OFF setting becomes equivalent to CONTINUE.
* 2
When the BATTERY REMAIN display setting is OFF, near end warning display does not occur.
* 3
The settings of USER1 to USER 5 and FACTORY are the same at the time of shipment from the factory.
* 4
(Continued on next page)