Panasonic BT-LH910G, Руководство по эксплуатации

Страница: 18 / 76

18
On-screen Display
The screen shows information such as the operating status display, picture adjusting knob status, sharpness
display, function display, audio level meter display, time code display, closed caption display, DC power
supply voltage and battery level display, and menu display.
Operating status display
DC14.0V
YP
B
P
R
1080/60i
50%
P-P FILM
8 4
1 2 6 5
7
3
1. The selected input line (page 10)
SDI1, SDI2, HDMI, VIDEO, YP •
B
P
R
, VF-YP
B
P
R
/VF-VIDEO, INT SG.
2. Signal format
“UNSUPPORT SIGNAL” appears if an unsupported signal is input. It may also indicate that the format •
selected in the “INPUT SELECT” menu does not match the input signal.
“NO SIGNAL” appears without input signal.
•
3. Various indications (PIXEL TO PIXEL mode)
This indicates the PIXEL TO PIXEL mode is engaged. •
4. Various indications (FILM mode)
This indicates that “GAMMA SELECT” of the “VIDEO CONFIG” is set to “FILM.” •
5. Various indications (warning of improper operation status for the camera settings)
This indicates there is an improper operation status relative to the camera settings. •
The condition to display differs depending on the type and settings of the camera used in combination •
with the unit. For details, see the instruction manual of the camera.
6. Various displays (lock setting)
This indicates that the front operations lock is on. (page 51) •
7. DC power supply voltage display
DC power supply voltage is displayed. •
8. Battery level display
When you are using an Anton/Bauer battery with a battery level display function, the battery level is •
indicated by the number of ■ and a percentage. When you are using a battery other than that or the AC
adapter, the display may not be shown or the battery level may not be indicated correctly. The battery
level is indicated by a numerical value in 5 % increments. Also, there are seven ■ segments to indicate
the battery level, and all seven of them are displayed until the battery level is approximately 70 %. After
that, the number of ■ is reduced by one for each 10 % reduction in battery power and no marks are
displayed when the battery level falls below approximately 10 %.
The indication can be turned ON/OFF in “BATTERY REMAIN” of the “SYSTEM CONFIG” menu (page 34).
•
<Notes>
The display state of the status can be set in “STATUS DISPLAY” of the “SYSTEM CONFIG” menu (page 34). •
“UNSUPPORT SIGNAL” and “NO SIGNAL” may not be properly displayed. •
For details on the operation status display in 3D Assist mode, refer to “3D Assist Mode” (page 52). •