12
Useful Information
Useful Information
Testing a terminal’s network speed
Once you have connected the adaptors where you plan to use them, follow the
procedure below to test the speed of each terminal’s network connection to the
master. Make sure that the terminal has already been registered to a master (see
page 15).
1.
Press and hold the terminal’s
SETUP
button for about 1 second.
•
The indicators light one at a time.
2.
After a few seconds, the network speed test result is displayed.
3.
Refer to the chart below to determine the network speed.
4.
If you are not satisfied with the speed test result, connect the terminal to a
different wall outlet and repeat the test.
Note
•
At least one indicator (“Good” network speed) must be lit in order to use the
terminal.
•
If you are not satisfied with the speed test result and have tried connecting the
terminal to different wall outlets, refer to the troubleshooting section (see
page 16).
•
If the electrical conditions in your home change, network speed may also
change.
Once you are satisfied with the terminal’s speed test result, you are ready to
connect each adaptor to a network device (broadband router, hub, computer,
network printer, network camera, etc.; see page 11).
PLC
LAN
MASTER
Network
speed
No link
Good
Less than
10 Mbps
*1
*1 Approximate data transmission speed when transmitting data using the UDP protocol.
Better
10 Mbps to
30 Mbps
*1
Best
More than
30 Mbps
*1
