2.4.1 Transferring Images by FTP
The following screen is displayed if you select to transfer images by FTP while configuring a timer, built-in
sensor, external sensor, or detection trigger (see Page 51 or Page 54). Follow the procedure below to configure
the camera to transfer images to an FTP site. Ask the FTP server administrator for the appropriate settings.
1.
Set the following parameters as desired.
a.
Enter the IP address or host name
of the FTP server.
•
An IPv6 address can be specified; note that the IPv6 address must be enclosed in brackets.
b.
Enter the port number used by the server. (Port 21 is normally used for FTP.)
c.
(user name) required to access the server (max. 63 characters).
d.
Enter the password
required to access the server (max. 63 characters).
e.
Select the desired setting for [Login Timing].
–
[Every Time]: The camera logs in to the server every time it transfers an image to the server.
–
[One Time]: The camera logs in to the server and stays connected for about 1 minute (unless a
new transfer begins before this time expires). This can reduce transfer time when several images
are transferred in a short time.
f.
Enter the desired name
for transferred files (max. 234 characters). Transferred files will be saved
using this file name.
•
You can specify existing directories on the server by entering “\” before the desired file name. For
example, if you enter “CameraImages\Image”, the camera will upload files to the
directory “CameraImages” and save the files using the name “Image”.
g.
Select the desired setting for [Overwrite setting].
–
[Overwrite File]: The file on the server is replaced by the file uploaded by the camera, i.e., only 1
file is saved on the server.
–
[Save as New File with Time Stamp]: A time stamp is added to the end of the file name, allowing
multiple files to be saved on the server. For example, if you set the file name as “Image”, an
Operating Instructions
61
2.4.1 Transferring Images by FTP
Содержание BL-C210 Series
