Panasonic AWE350P - COLOR CAMERA, Инструкция по эксплуатации

Страница: 40 / 84

- 40 -
O
COLOR PHASE ADJUSTMENT
Supply the output signal (split color bar) from the
color special effect generator to a color monitor or
vectorscope. Adjust the color phase of the camera.
[ADJUSTMENT by CAMERA or multi hybrid control panel]
1. Press the NO/BAR switch for over 5 seconds for the
color bar mode.
2. Select [G/L Adjustment] on the main menu, then
select [SC Coarse] on the sub menu.
3. Make coarse adjustment with the YES/ABC switch
and the NO/BAR switch.
4. Select [SC Fine] on the sub menu. Perform fine
adjustment with the YES/ABC switch and the
NO/BAR switch.
For details on the menu operations using the multi hybrid
control panel, refer to the Operating Instructions of the
multi hybrid control panel.
[ADJUSTMENT with RCU]
Use the subcarrier phase coarse adjustment control and
subcarrier phase fine control.
* It is recommended that a vectorscope be used for
maximum accuracy in color phase adjustment.
CAUTION:
When color phase adjustment is required using RCU,
color bar/camera selector switch should be set to BAR.
Color phase cannot be adjusted if the switch is in the
CAM position. After adjustment set color bar/camera
selector switch back to CAM.
Color bar of
camera
Color bar of special
effects generator
Sprit line