![background image](http://html1.mh-extra.com/html/panasonic/aw-ue150wp/aw-ue150wp_operating-instructions-manual_3706627047.webp)
Operating Instructions
12 V
IN
IR ID AUDIO IN
RS-422
SERVICE
MONI OUT 12G SDI OUT
3G SDI OUT G/L IN
LAN
LINK ACT
OPTICAL
1
2
3
4
5
6
7
5
8
6
23
9
10
11 12
14
21 22
20
19
18
17
16
15
13
Rear panel
Bottom panel
1.
Mount bracket for installation surface (supplied
accessory)
Mount this bracket onto the installation surface, and then attach the
camera main unit to the bracket.
2.
Drop-prevention wire
This wire is screwed down to the bottom panel of the camera main
unit. Loop the circle part of the wire around the hook of the mount
bracket.
3.
Status display lamp
This lights in the following way depending on the status of the unit.
Orange Light up
When the standby status is established
Blink twice
When a signal not matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
Green
Light up
When the power is on
Blink twice
When a signal matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
Blinking
rapidly
When the initialization process is complete
Red
Light up
When trouble has occurred in the unit
Blinking
slowly
Firmware being updated
Blinking
rapidly
When a PoE++ software authentication error has
occurred
4.
Tilt head
This rotates in the right and left direction.
5.
Wireless remote control signal light-sensing area
The light-sensing area is provided in three places, on the front panel
of the camera pedestal and at the top of the rear panel.
6.
Hole for securing the camera pedestal
This hole is provided in the bottom panel of the camera pedestal.
7.
Camera head
This rotates in the up and down direction.
8.
Tally lamp
This comes on or goes off in response to the control from the
controller but only when “On” has been selected as the tally lamp use
setting. The tally lamp is red or green.
9.
LAN connector for IP control <LAN LINK/ACT>
This LAN connector (RJ-45) is connected when exercising IP control
over the unit from an external device. Use a LAN cable (category 5e
or better, maximum 100 m (328 ft)) for connection.
Parts and their functions
Camera unit
46
47
Содержание AW-UE150WP
Страница 71: ...MEMO 71 ...
Страница 72: ...Web Site http www panasonic com Panasonic Corporation 2018 ...