Panasonic AW-RC400E, Руководство по эксплуатации

Страница: 9 / 272

=
Guide pin
Use this to determine the direction in which the camera is
to be mounted.
> Camera mounting screws (U1/4” 20UNC)
These are used to secure the camera firmly after it has
been mounted.
? Side blank panel
This is used when the mounting direction of the pedestal
connector panel is to be changed.
@ SDI IN connector [SDI IN]
Use a coaxial cable to connect this to the SDI OUT
connector on the AW-PB504 SDI card or other card
installed in the convertible camera.
A
ENG LENS CONTROL connector
[ENG LENS CONTROL]
Use this when an ENG lens is to be used.
An optional connecting cable is required.
B OPTION connector [OPTION]
The optional AW-RL400 roll unit is connected here using
the cable supplied with the AW-RL400.
C
LENS I/F connector [LENS I/F]
This is used to control the zooming and focusing of the
motorized lens unit. Use the motorized lens unit’s remote
(zoom/focus) control cable to make the connection.
D CAMERA I/F connector [CAMERA I/F]
This is used for the control of the convertible camera.
Use the camera cable supplied with the AW-PH400 to
connect the connector with the REMOTE connector on
the camera.
Depending on the functions of the optional card, a special
camera cable (sold separately) is required.
E
ND/EXT connector [ND/EXT]
This is for the control of the ND filter and lens extender of
the motorized lens unit.
Connect this connector when using a motorized lens unit
with ND filter and lens extender functions.
The compatible connector is the R03-P6M or R03-PB6M
made by Tajimi Electronics Co., Ltd.
F TALLY OFF/ON switch [TALLY]
When this is set to ON, the tally lamp is lit by the selected
signals. When it is set to OFF, the (
6 ) tally lamp will not
light even if the selected signals are supplied.
G CONTROL IN IP/RP connector [IP/RP]
This is the connector for the control of signals of the
camera and pan/tilt head.
It is connected to the CONTROL OUT TO PAN/TILT
connector on the AW-RP400 pan/tilt head controller.
Use a 10BASE-T (equivalent to UTP category 5) straight
cable for the connecting cable.
H VIDEO connector [VIDEO]
This the output connector for the camera’s video signals.
It is connected to the Y/VIDEO connector on the
AW-RC400 cable compensator or monitor, etc.
Use a BNC coaxial cable for the connecting cable.
I
CABLE COMP OFF/ON switch [CABLE COMP]
When this is set to ON, signals which have been cable-
compensated for the equivalent of 500 meters are output
from the VIDEO connector and the Y, Pr and Pb
connectors.
When this switch is used in conjunction with the
AW-RC400 cable compensator, the video cable can be
extended up to a maximum of 1000 meters.
Indoor Pan/Tilt Head AW-PH400
8 (E)
ENGLISH
Parts and their function
A F
B E
C D
ND signal CVCC (+12V)
CGND ND return
EXT return
EXT signal
(Pin layout as seen from cable end)