13
t
t
Installation
(The installation work must be performed by your dealer without fail.)
$
Installing the pan-tilt head
Be absolutely sure to follow the instructions below when installing the pan-tilt head.
Failure to do so may cause the pan-tilt head to slip out of position or fall.
O
Make sure that the installation of the pan-tilt head has been completed before
mounting the camera onto it.
O
To mount the pan-tilt head, use the four mounting holes and secure it firmly in place.
O
Have M6 hexagonal bolts ready as these must be used for mounting the pan-tilt head.
O
The hexagonal bolts must be long enough to meet the requirement of “mounting
material thickness (t) plus 25 mm or longer.”
O
Use flat washers, spring washers and hexagonal nuts with the hexagonal bolts, as
shown in the figure.
O
Use a wrench that fits the size of hexagonal bolt heads to tighten the hexagonal bolts.
O
For suspended installation, pass a wire through the safety wire mounting hole, and
fasten it securely to the ceiling or other structurally sound object.
O
Have a wire ready which is strong enough to bear the weight of the entire pan-tilt head
system (pan-tilt head, camera, lens and cable).
O
Install the pan-tilt head so as to ensure that none of the components mounted on the
pan-tilt head or cables will come into contact with any objects in the vicinity when the
pan-tilt head rotates.
<Note>
When installing the pan-tilt head, refrain from forcibly turning the head or tilting arm by
hand.
Doing so may cause the unit to malfunction.
Safety wire
