- 5 -
- 5 -
Parts and Their Functions
Mounting on the camera
1
Take the rear lens cap off.
2
Rotate the mount clamp ring on the camera
fully counterclockwise as viewed from front of
the lens.
3
Fit the mounting surface of the lens with that
of the camera aligning the pin on the lens with
the slot in the camera.
4
Rotate the mount clamp ring fully clockwise.
5
Connect the “Cable to camera” to the
connector, provided for the lens with, on the
camera.
6
Connect the “Cable for control” to the
connector on a pan-tilt head.
For remote control, use an extension cable
(option) to link the lens with a pan-tilt head.
Prior to installation of the lens, turn off the power of the camera.
7.3
14
3.3 1
1.2
LE
NS
-J
AP
PH
OT
O
O
P
T
IC
A
L
C
O
4
2
5
4
0
0
0
1
LOCK
FREE
Pin
Camera
Mount clamp ring
7.3
14
3.3 1
1.2
LE
NS
-JA
P
PH
OT
O
O
P
T
IC
A
L
C
O
4
2
5
4
0
0
0
1
L
O
C
K
F
R
E
E
@
Iris gain adjusting trimmer
There is no need for adjustment usually. If
any errors occur due to any reasons,
however, adjustment can be done without
removing the cover.
The iris gain adjusting trimmer becomes
visible inside by removing the rubber cap on
one side of the drive unit. Operate the
trimmer with a small screwdriver.
Rotate the trimmer clockwise for higher gain
and counterclockwise for lower gain. When
increasing the gain, care should be taken not
to cause hunting.
@