Panasonic AW-HE20WP, Руководство по эксплуатации

Страница: 10 / 96

10

Do not install or use the unit in
the following kinds of locations.

On walls (where the unit would be
installed sideways)

In locations (including places such as
under the eaves of a building) where
the unit would be directly exposed to
rain or water

In locations such as kitchens where
there are high concentrations of
steam and grease

In outdoor locations or hot places
where the temperature will exceed
40
° C
(104
° F
)

In cold locations where the
temperature will drop below 0
° C
(32
°F)

In locations where the humidity will
exceed 85%RH

In locations where chemicals are
used such as near swimming pools

At sea, in coastal areas or in locations
where corrosive gases are emitted

In locations where radiation, X-rays,
or strong radio waves or magnetic
fields are generated

In locations where the unit would be
subject to a great deal of vibration
such as on board a vehicle or ship
(this unit is not designed to be used in
vehicles)

In locations where the temperature is
subject to sudden changes such as
near the air outlet of an air conditioner
or near a door which allows the
outside air to come in.

Be absolutely sure to use the
supplied brackets and screws to
install the camera.

Do not mount the unit by employing
any methods other than those
specified.

Do not remodel the mounting bracket
or mounting screws provided with the
unit.

What to avoid to ensure that the
unit will perform stably over a
prolonged period

Using the unit for a prolonged period in
a location with high temperature and
humidity levels will cause its parts to
deteriorate and shorten its service life.

Ensure that a cooling unit or heating
unit will not blow any air directly toward
the installation location.

Before installation, always
disconnect the DC connector
When installing, always use the supplied
components. Do not disassemble or modify
the wall mount adaptor.

Tightening up the mounting
screws

Tighten up the screws and bolts
securely to the degree that is
appropriate for each of the materials
used in the mounting location and
structures.

After tightening up the screws and
bolts, check that there is no
unsteadiness and that the parts have
been tightened securely.

Use the specified tools and tighten the
screws firmly.

Tighten up the screws using the
specified torque driver. Do not use
electrical drivers or impact drivers.