Panasonic AV-HS60C3G, Руководство по эксплуатации

Страница: 118 / 176

– 118 –
Chapter 7 Configuring Operations — Setting the operation mode
Setting the operation mode
Setting the operation mode for the crosspoint buttons
Selecting a bus using the SHIFT function
The SHIFT function is used to assign four sources to one crosspoint button (the KEY, PGM/A, or PST/B bus crosspoint button) and change pages using
the <2nd PAGE>/<3rd PAGE> buttons on the right of the source name display panel.
There are two operation methods for the SHIFT function:
All SHIFT
Use the <2nd PAGE>/<3rd PAGE> buttons to change all source pages for the crosspoint buttons included in the
corresponding ME at once.
Single SHIFT
Operate by assigning the <2nd PAGE>/<3rd PAGE> button to the crosspoint buttons with the menu.
Use the assigned button to change the source page of the crosspoint buttons included in the corresponding ME on a bus
basis. In this case, the <2nd PAGE>/<3rd PAGE> buttons on the right of the source name display panel can be used to
switch the source name displays.
The <2nd PAGE>/<3rd PAGE> buttons can be used in two modes.
1
Select the <OPR> button
→
[OTHER SETTINGS]
→
[Page Mode] tab.
2
Set an item in [2nd Page Button] and [3rd Page Button] in the [Page Mode] column.
[Normal] Enabled only while the button is pressed.
[Page Lock] Enabled and disabled every time the button is pressed.
Assign the SHIFT function to the crosspoint buttons
1
Select the <PANEL> button → [XPT ASSIGN] → [Panel1]/[Panel2]/[Panel3] tab.
[Panel1] tab Assigns the control panel 1.
[Panel2] tab Assigns the control panel 2 (second Control Panel).
[Panel3] tab
Assigns the control panel 3 (third Control Panel).
2
Select the buttons to assign the SHIFT function from the button list in the left column.
f
For details on the button assignment of the crosspoint area, refer to “Assigning signals to buttons”.
3
Select [2nd Page] or [3rd Page] from the signal list in the right column.
f
[2nd Page] and [3rd Page] are displayed when [Special] is selected in [Page Select].
4
Select [Assign].
f
The SHIFT function is assigned to the button selected in the step
2
.
f
Once the assignment is set on one page, the corresponding button on other pages works in a same way.
Selecting the bus mode
Select the A/B bus system or the flip-flop system (PGM/PST system).
1
Select the <OPR> button
→
[OTHER SETTINGS]
→
[Bus Mode] tab.
2
Set an item in [Bus Mode Type] in the [Bus Mode] column.
[Common]
Sets the same bus mode in ME1 and ME2.
Setting of the [Bus Mode] column → [Bus Mode] is applied to both ME1 and ME2.
[Each]
Different bus modes can be set for ME1 and ME2.
Settings of the [Each Bus Mode] column → [Bus Mode ME1] and [Bus Mode ME2] are applied to ME1 and ME2
respectively.
Setting the transition operation mode
Setting the time display unit
The time display unit used in this unit can be set as a second/frame basis or a frame basis.
1
Select the <OPR> button
→
[OTHER SETTINGS]
→
[Transition] tab.
2
Select an item in [Time Unit] in the [Time Unit] column.
[Sec/Frame] Sets the time display unit as a second/frame basis.
[Frame] Sets the time display unit as a frame basis.
f
The maximum possible setting time is 16s19f (499 frames).